Specifications

4000326 Rev A xi
Safety Precautions,
Continued
Safe Software Operation
The software described in this guide is used to monitor and/or control Scientific-
Atlanta and other vendors’ electrical and optical equipment designed to transmit
cable TV signals. Certain safety precautions should be observed when operating
equipment of this nature.
For product specific safety requirements, refer to the appropriate section of the
documentation accompanying your product.
For safe operation of this software product, refer to the following warnings.
WARNINGS:
•
Ensure that all optical connections are complete or terminated before using
the product to remotely control a laser device. An optical or laser device can
pose a hazard to remotely located personnel when operated without their
knowledge.
•
Allow only personnel trained in laser safety to operate the software product.
Otherwise, injuries to personnel may occur.
•
Restrict access to the software product to authorized personnel only.
•
Install the software product in a restricted access area.
Enclosure
• Do not allow moisture to enter the products.
• Do not open the enclosure of the products unless otherwise specified.
• Do not push objects through openings in the enclosure of the products.
Cables
• Always pull on the plug or the connector to disconnect a cable. Never pull on the
cable itself.
• Do not walk on or place stress on cables or plugs.
Fuse
• Always use a fuse that has the correct type and rating. The correct type and rating
is indicated on the products.
• Always disconnect all power cables before you change a fuse.
Service
Refer service only to service personnel who are authorized by Scientific-Atlanta.