Specifications

1-108 Transmitters 4000326 Rev A
Monitor Status Parameters Using the ICIM,
Continued
Monitoring Status Parameters
From the MAIN or SCROLL menus on the ICIM, navigate to the Prisma II 1550 nm
Transmitter MODULE menu. From the MODULE menu, press the
STA T
key to
display the STATUS menu.
The following table describes each transmitter status parameter.
Parameter Units Meaning Typical Value
OutPwr1 dBm Optical output power at port 1 +9.0 dBm
OutPwr2 dBm Optical output power at port 2 +9.0 dBm
LasBias mA Measured laser current 270 mA
InRF dB Relative RF input power 0.0 dB
ModTemp °C Module temperature Ambient °C + 15.0°
CPLock N/A Constant power loop locked 0.004 #
TecCur A Measured TEC current 0.2A
LasTemp °C Laser temperature 30.0°C
Enable N/A Laser on or off On
CwMode N/A Continuous wave mode Off
LoRFInh N/A Low RF input alarm status Off
ModBias V Modulator bias 0.028 V
Sbs1Stat N/A SBS PLL #1 lock Lock
Sbs2Stat N/A SBS PLL #2 lock Lock
Psbs2G N/A 2 GHz SBS power level 146.1
Psbs6G N/A 6 GHz SBS power level 146.1
-5VInt VN/A Internal -5 V power level -5 V
+12VInt V Internal +12 V power level +12 V
Continued on next page