Installation Guide

4030542 Rev B 19

Installation

To install the Mini FiberLinX-II into a network environment, connect the proper

twisted-pair and fiber cables. In a standalone configuration, or if direct management

is desired, assign an IP address to the Mini FiberLinX-II after installation. Refer to

Assigning IP Information (on page 27) for information on assigning an IP address.

Usage in Pairs

Single-strand fiber products use optics that transmit and receive on two different

wavelengths. Therefore, these products must be used in pairs or connected with

compatible single-strand fiber products.

For example, a Mini FiberLinX-II, TX/SSFX-SM1310-SC transmits on 1310 nm and

receives on 1550 nm. It must be paired with a product which transmits on 1550 nm

and receives on 1310 nm, such as a Prisma FiberLinX-II, TX/SSFX-SM1550-SC.

The two connected products must also have the same speed and distance

capabilities. For example, both must be single-mode (20 km) or single/PLUS (40

km).

Autocross Feature for Twisted-Pair Connection

All twisted pair ports on the Mini FiberLinX-II include AutoCross, feature that

automatically selects between a crossover workstation and a straight-through

connection depending on the connected device.