Installation Guide

4007998 Rev B Prisma Gigabit Ethernet Media Converter Module Installation Instructions 9
Configuration Instructions, Continued
Unmanaged Modules
Before installing the module, configure the modules for desired features. The
diagram below shows the switch location on the module. The chart below states the
available features and settings for the module. After configuring the switch for the
desired settings, install the module and connect the appropriate cables. Refer to
Installing the Prisma Gigabit Ethernet Media Converter Module later in these
instructions for installation instructions.
DISABLE ENABLE
S1
8
7
6
5
4
3
2
1
ON
} } } }
}
Set at
Factory
DO NOT
CHANGE
Forced/Preferred
TX LinkLoss
FiberAlert
Master/Slave Mode
}
FX Auto-Negotiation
Switch Configuration Table
Feature Switch Default
Forced/Preferred* DIP Switch 1 on S1 ON
Master/Slave* DIP Switch 2 on S1 ON
TX LinkLoss DIP Switch 3 on S1 OFF
FiberAlert DIP Switch 4 on S1 OFF
FX Auto-Negotiation DIP Switch 5 on S1 OFF
* These features are hardware configurable ONLY. Please make sure DIP switches
are set appropriately for your configuration requirements.