Installation Guide

8 Prisma Gigabit Ethernet Media Converter Module Installation Instructions 4007998 Rev B
Configuration Instructions
Introduction
The Prisma Gigabit Ethernet Media Converter modules have user-configurable
features. Refer to the table in Switch Configuration Table later in these instructions
for available features.
Instructions for configuring both managed (via an SNMP-compatible management
application like PrismaView
™
) and unmanaged modules follow.
Managed Modules
To manage one or more modules, an SNMP agent must be present in the chassis:
some chassis have embedded management; other chassis use an SNMP management
module. To configure managed modules, install the module first. Refer to
Installing the Prisma Gigabit Ethernet Media Converter Module later in these
instructions for installation instructions. Then, configure using the management
software. Refer to the PrismaView software for Media Converters online help file for
more information and assistance.
Note: Management software will override hardware settings (e.g., jumper, switch,
etc.), so you MUST configure a module that will be managed via the software. Until
you configure a managed module via the software, the module (and its LEDs) may
not work properly.
Continued on next page