System information

Open and resolved caveats in TC6
67
Reference ID
Endpoint /
Device
Versions
affected
Fix
Target
Summary
CSCug56502
Touch 8
6.0.x
6.1.0
6.1.1/
6.2.0
Touch UI: Need easy way to enter dot (.) from the
dial pad for IP address dialling
CSCug03464
SX20
6.1.0
6.1.1
Encryption icon is not shown on Touch and OSD
although the call is encrypted.
CSCug56483
MX series
6.1.0
6.1.1
MX series camera preset functionality broken.
CSCug37656
All TC
endpoints
6.0.x
6.1.0
6.2.0
Fan status in system information on web might be
misinterpreted. Although it may report “fans not
running” or “can’t match [RPM] rpm” it does not
mean that the system is faulty or that there is a
problem with the fans. If the system is operating
within the temperature specification, customer or
TAC should take no action. The diagnostic
messages and system information statuses will be
improved.
CSCuf93352
SX20
6.0.x
6.2.0
When an SX20 is in standby mode and is reloaded
from the GUI, it comes up correctly, however, the
display connected to HDMI1 does not come out of
standby. The display on HDMI2 comes correctly out
of standby.
CSCue78225
Touch 8
6.0.x
6.2.0
When starting a presentation from the Touch 8”, the
presentation dialog goes to the secondary camera
instead of the PC. PC input has been set as the
default presentation source.
CSCug13558
All TC
endpoints
6.0.x
6.2.0
The remote service supports the use of anonymous
SSL ciphers.
CSCue62562
All TC
endpoints
6.0.x
6.2.x/7.x
When a login is required for the OSD
(xConfiguration Video OSD LoginRequired: on),
only a username and PIN are required to log into
the OSD. Thus, if no PIN is configured, non-admin
users can log into the OSD as admin, giving them
access to admin-level system configuration. No
password is required.
CSCug13548
All TC
endpoints
6.0.x
6.1.x
6.2.0
The remote service supports the use of medium
strength SSL ciphers
CSCue94398
Touch 8
6.0.x
6.1.x
6.2.0
When setting PresentationSelection hidden, the
input is still available in Touch UI.
CSCug06492
All TC
endpoints
5.x
6.x
6.2.x
A switch is configured with a default data VLAN on a
switch port. It tags all packets, also EAP packets
with the DATA VLAN. When xConfiguration Network
1 VLAN Voice Mode is set to Off we can read this
packet even though it is tagged with VLAN. When
we set VLAN mode to auto or manual we discard
any packet that is not tagged with our VLAN.
CSCug06474
All TC
endpoints
5.x
6.x
6.2.x
When using 802.1x and VLAN and the same time,
we tag the EAP packets with a VLAN tag. The
switch does not accept packets tagged with VLAN,
hence 802.1x authentication fails.
CSCue91808
All TC
endpoints
6.0.x
6.1.x
6.2.0
Presentations made from TC based Cisco
TelePresence codecs may not visible by remote
participants due to the presentation channel spiking
outside of QoS boundaries in a cyclic manner.