System information

Open and resolved caveats in TC6
66
Reference ID
Endpoint /
Device
Versions
affected
Fix
Target
Summary
CSCug06492
All TC
endpoints
5.x
6.x
6.2.x
A switch is configured with a default data VLAN on a
switch port. It tags all packets, also EAP packets
with the DATA VLAN. When xConfiguration Network
1 VLAN Voice Mode is set to Off we can read this
packet even though it is tagged with VLAN. When
we set VLAN mode to auto or manual we discard
any packet that is not tagged with our VLAN.
CSCug06474
All TC
endpoints
5.x
6.x
6.2.x
When using 802.1x and VLAN and the same time,
we tag the EAP packets with a VLAN tag. The
switch does not accept packets tagged with VLAN,
hence 802.1x authentication fails.
CSCue91808
All TC
endpoints
6.0.x
6.1.x
6.2.0
Presentations made from TC based Cisco
TelePresence codecs may not visible by remote
participants due to the presentation channel spiking
outside of QoS boundaries in a cyclic manner.
CSCug09690
Touch pairing
6.0.x
6.1.x
6.2.0
Reverse DNS lookup for SSH may take a very long
time to succeed with a bad DNS configuration,
which may cause a time out the SSH pairing
between touch and endpoint. Solution is to increase
time out and remove reverse DNS lookup when
doing SSH.
CSCug48377
TC endpoints
with Dual
Monitor
configuration
6.1.0
6.2.0
When setting a monitor to:
* PresentationOnly in all monitorroles
* Second in DualPresentationOnly
the background/wallpaper needs to be displayed.
Open caveats in TC6.1.0
For open caveats regarding other endpoints/vendors, see the interoperability section.
Reference ID
Endpoint /
Device
Versions
affected
Fix
Target
Summary
CSCuh50086
All TC
endpoints
6.1.x
6.2.0
H323 Multiway Accept&Merge fails in 6.1.x
CSCug76672
All TC
endpoints when
using VCS
6.0.x
6.1.x
6.2.0
The encryption padlock does not appear when
encryption is set to ON. It does not help to set the
GUI EncryptionIndicator to “Always On”. The
functionality used to be like this:
If Encryption is set to “On” then always display the
padlock in call.
CSCuh37718
TC endpoints
using remote
control
6.1.x
6.2.0
Enabling Do Not Disturb is implemented in different
ways on OSD and Touch. On Touch it will
automatically be turned off after x minutes defined
by xConfiguration Conference 1 DoNotDisturb
DefaultTimeout. Using the Remote it will be enabled
until turned off.