System information

Open and resolved caveats in TC6
60
Reference ID
Endpoint /
Device
Versions
affected
Fix
Target
Summary
by xConfiguration Conference 1 DoNotDisturb
DefaultTimeout. Using the Remote it will be enabled
until turned off.
CSCug37656
All TC
endpoints
6.x
6.3.0
Fan status in system information on web might be
misinterpreted. Although it may report “fans not
running” or “can’t match [RPM] rpm” it does not
mean that the system is faulty or that there is a
problem with the fans. If the system is operating
within the temperature specification, customer or
TAC should take no action. The diagnostic
messages and system information statuses will be
improved.
CSCue62562
All TC
endpoints
6.0.x
7.x
When a login is required for the OSD
(xConfiguration Video OSD LoginRequired: on),
only a username and PIN are required to log into
the OSD. Thus, if no PIN is configured, non-admin
users can log into the OSD as admin, giving them
access to admin-level system configuration. No
password is required.
CSCug06492
All TC
endpoints using
802.1x
5.x
6.x
6.3.x
A switch is configured with a default data VLAN on a
switch port. It tags all packets, also EAP packets
with the DATA VLAN. When xConfiguration Network
1 VLAN Voice Mode is set to Off we can read this
packet even though it is tagged with VLAN. When
we set VLAN mode to auto or manual we discard
any packet that is not tagged with our VLAN.
CSCug06474
All TC
endpoints
5.x
6.x
6.3.x
When using 802.1x and VLAN and the same time,
we tag the EAP packets with a VLAN tag. The
switch does not accept packets tagged with VLAN,
hence 802.1x authentication fails.
CSCui79481
TC endpoints
All
7.x
When a system is upgraded the current logs are not
stored. After the upgrade, only the historical logs will
be available, not the logs from the time of the
upgrade.
Open caveats in TC6.2.0
For open caveats regarding other endpoints/vendors, see the interoperability section.
Reference ID
Endpoint /
Device
Versions
affected
Fix
Target
Summary
CSCuh04746
TC endpoints
using remote
control
6.1.x
6.2.x
6.3.0
Self-view has to be manually moved to the selected
monitor specified by xconfiguration Video
SelfviewDefault OnMonitorRole.