System information

New feature descriptions TC6.2.0

• Active Control (IX) is not supported with ICE

• Not supported by CUCM until CUCM 10 (registration and calls without ICE will work but calls

requiring ICE will fail)

• ANAT must be turned off, which is the default setting. (ANAT Applies to Dual Stack Call protocol

mode. SDP will have both an IPv4 and IPv6 address. This feature should not be used yet.)

• Entities in the call flow that are not compatible or accepting the ICE signaling may cause these

calls to be rejected or filter out the ICE media lines. If an ICE enabled endpoint is calling an

endpoint without ICE support or ICE enabled, the media will most likely not pass through. This is

because both endpoints are required to participate in the ICE negotiation to open a blocking NAT

or firewall, and the ICE endpoint may present its non-reachable host address in the initial media

offer. In a VCS scenario, the VCS will do a traversal call if it detects that one endpoint behind a

NAT/firewall is not doing ICE.

Active Control: Providing end users conference control with TelePresence

Server

Active control is a feature that helps conference participants to administer a conference on

TelePresence Server through a Touch panel.

End users can interact with the TS to control the meeting experience. Each user can see the

participant list, change video layout, disconnect participants, etc. from the touch interface.

Active Control Features in TC 6.2 (Phase 1):

• Participant lists  Friendly name and caller id.

• Change layout locally  Applies to Main video channel only. When presentation is active, the

layout will only select where to put main video or presentation.

• Conference information  Name of the conference

• Mute remote participant  This feature will be added in TC6.3

• Disconnect remote participant

• See who is active speaker  An icon appears next to the speaker in the participant list

• See who is presenting  A PC icon appears next to the speaker in the participant list

Pre-requisites and requirements:

• Requires TelePresence Server 3.1 or later in remote management,

• Must be behind a Conductor (XC2.2 and later), not directly registered to VCS/CUCM

• CUCM version 9.1.2 or later

• VCS version X7 or later