Specifications

11-37
Cisco Security Appliance Command Line Configuration Guide
OL-6721-01
Chapter 11 Configuring Failover
Configuring Failover
Show Failover—Active/Active
The following is sample output from the show failover command for Active/Active Failover. Table 11-5
provides descriptions for the information shown.
hostname# show failover
Failover On
Failover unit Primary
Failover LAN Interface: third GigabitEthernet0/2 (up)
Unit Poll frequency 1 seconds, holdtime 15 seconds
Interface Poll frequency 4 seconds
Interface Policy 1
Monitored Interfaces 8 of 250 maximum
failover replication http
Group 1 last failover at: 13:40:18 UTC Dec 9 2004
Group 2 last failover at: 13:40:06 UTC Dec 9 2004
This host: Primary
Group 1 State: Active
Active time: 2896 (sec)
Group 2 State: Standby Ready
Active time: 0 (sec)
admin Interface outside (10.132.8.5): Normal
admin Interface third (10.132.9.5): Normal
admin Interface inside (10.130.8.5): Normal
admin Interface fourth (10.130.9.5): Normal
ctx1 Interface outside (10.1.1.1): Normal
ctx1 Interface inside (10.2.2.1): Normal
ctx2 Interface outside (10.3.3.2): Normal
ctx2 Interface inside (10.4.4.2): Normal
Other host: Secondary
Group 1 State: Standby Ready
Active time: 190 (sec)
Group 2 State: Active
Active time: 3322 (sec)
admin Interface outside (10.132.8.6): Normal
admin Interface third (10.132.9.6): Normal
admin Interface inside (10.130.8.6): Normal
admin Interface fourth (10.130.9.6): Normal
ctx1 Interface outside (10.1.1.2): Normal
ctx1 Interface inside (10.2.2.2): Normal
ctx2 Interface outside (10.3.3.1): Normal
ctx2 Interface inside (10.4.4.1): Normal
Stateful Failover Logical Update Statistics
Link : third GigabitEthernet0/2 (up)
Stateful Obj xmit xerr rcv rerr
General 1973 0 1895 0
sys cmd 380 0 380 0
up time 0 0 0 0
RPC services 0 0 0 0
TCP conn 1435 0 1450 0
UDP conn 0 0 0 0
ARP tbl 124 0 65 0
Xlate_Timeout 0 0 0 0
VPN IKE upd 15 0 0 0
VPN IPSEC upd 90 0 0 0
VPN CTCP upd 0 0 0 0
VPN SDI upd 0 0 0 0
VPN DHCP upd 0 0 0 0