Specifications

1-5
PIX 515E Security Appliance Getting Started Guide
78-17645-01
Chapter 1 Installing and Setting Up the PIX 515E Security Appliance
Setting Up the Security Appliance
Figure 1-4 PIX 515E Security Appliance Back Panel
Setting Up the Security Appliance
This section describes the initial configuration of the security appliance. You can
perform the configuration steps using either the browser-based Cisco Adaptive
Security Device Manager (ASDM) or the command-line interface (CLI).
However, the procedures in this chapter refer to the method using ASDM.
Note To use ASDM, you must have a DES license or a 3DES-AES license. For more
information, see Appendix A, “Obtaining a DES License or a 3DES-AES
License.”
This section includes the following topics:
• About the Factory-Default Configuration, page 1-6
• About the Adaptive Security Device Manager, page 1-6
• Using the Startup Wizard, page 1-7
97784
DO NOT INSTALL INTERFACE
CARDS WITH POWER APPLIED
CONSOLE10/100 ETHERNET 0
ACT
LINK
LINK
100 Mbps
ACT
100 Mbps
FAILOVER
USB
10/100 ETHERNET 1
PIX-515
10/100BaseTX
ETHERNET 0
(RJ-45)
10/100BaseTX
ETHERNET 1
(RJ-45)
Console
port (RJ-45)
Power switch
ACT
LED
100 Mbps
LED
LINK
LED
ACT
LED
100 Mbps
LED
LINK
LED
USB