Installation guide

4-16

Cisco PIX Firewall Hardware Installation Guide

78-13880-01

Chapter 4 PIX 515/515E

Installing a Circuit Board in a PIX 515/515E

The information in this section refers to both the AC and DC models of the PIX 515/515E.

Complete these steps to install a circuit board in a PIX 515/515E:

Step 1 Locate the grounding strap from the accessory kit. Fasten the grounding strap to your wrist so that it

contacts your bare skin. Attach the other end to bare metal inside the PIX 515/515E chassis as shown

in Figure 4-19.

Figure 4-19 Attaching the PIX 515/515E Grounding Strap

Step 2 Remove the screws from the rear assembly on the left and put the assembly aside.

DO NOT INSTALL INTERFACE

CARDS WITH POWER APPLIED

CONSOLE10/100 ETHERNET 0/0

Link

FDX

100 Mbps

Link

100 Mbps

FAILOVER

10/100 ETHERNET 0/0

PIX-515

24304

Copper foil