Specifications

Configuring Bridge Groups Using the 12E/2FE VLAN Configuration WebTool on the Cisco 7200 Series Routers

PA-12E/2FE Ethernet Switch 10BASE-T and 100BASE-TX Port Adapter Installation and Configuration

6-26

Note When you remove a bridge group, all interfaces associated to the removed bridge

group are given no bridge group status, the bridge-group number is removed from its

assigned color, and the assigned color is removed from the bridge group’s interfaces.

Note The status line of the WebTool will indicate if the number speciﬁed for the bridge

group you want to remove exists or is out of the acceptable range (1-63).

Figure 6-16 Verifying a Deleted Bridge Group

Step 4

Repeat Step 1 through Step 3 for additional bridge groups.

Step 5 Save the change by selecting the Save Conﬁg option from the Bridge-Group pull-down

menu. (See Figure 6-6.)

This completes the procedure for deleting a bridge group.

For additional information about accessing your router’s home page and using the Cisco Web

browser interface, refer to the “Understanding the User Interface” chapter of the Conﬁguration

Fundamentals Conﬁguration Guide.

NM6409

Selected 12E/2FE interface 5/0 Bridge group 1 has been removed

Updated bridge group 1 status