Specifications

Configuring the 12E/2FE Interfaces 6-25
Deleting a Bridge Group
Figure 6-14 Verifying the Removed Interface
Step 3
Repeat Step 1 and Step 2 for additional interfaces.
Step 4 Save the change by selecting the Save Config option from the Bridge-Group pull-down
menu. (See Figure 6-6.)
This completes the procedure for removing a 12E/2FE interface from a bridge group.
Deleting a Bridge Group
Complete the following steps to delete a bridge group:
Step 1 In the WebTool, select the Delete option from the Bridge-Group pull-down menu. (See
Figure 6-6.) The Delete Bridge-Group dialog box appears. (See Figure 6-15.)
Step 2 In the Delete Bridge-Group dialog box, enter the bridge-group number and select OK.
Note The acceptable range of bridge-group numbers is from 1 to 63.
Figure 6-15 Delete a Bridge-Group Dialog Box
Step 3
After entering the bridge-group number and selecting OK in the Delete Bridge-Group
dialog box, make sure the status line of the WebTool indicates that the bridge group was
removed and that the removed bridge group is not listed in the Bridge-Groups list box.
(See Figure 6-16.)
NM5540
Selected 12E/2FE interface 5/0
Updated 12E/2FE
interface 5/0 status
No bridge group selected