Specifications

Configuring Bridge Groups Using the 12E/2FE VLAN Configuration WebTool on the Cisco 7200 Series Routers

PA-12E/2FE Ethernet Switch 10BASE-T and 100BASE-TX Port Adapter Installation and Configuration

6-24

Note To shut down an interface, deselect the administrative check box below an

interface.

Figure 6-13 Bringing Up an Interface

Step 4

Repeat Step 1 through Step 3 for additional interfaces and bridge groups.

Step 5 Save the change by selecting the Save Conﬁg option from the Bridge-Group pull-down

menu. (See Figure 6-6.)

This completes the procedure for adding a 12E/2FE interface to a bridge group.

Removing an Interface From a Bridge Group

Complete the following steps to remove a 12E/2FE interface from a bridge group:

Step 1 In the WebTool, select the 12E/2FE interface you want to remove.

Note To display the status of a 12E/2FE interface (its assigned bridge-group and

administrative state [up or down]) in the status line of the Webtool, place your cursor over

the interface.

Note To select multiple 12E/2FE interfaces, hold down the Shift key as you select each

interface.

Step 2 After selecting the 12E/2FE interface you want to remove, select the None option (next

to the Bridge-Groups colored buttons). (See Figure 6-14.)

NM6406

Administrative check box

Updated 12E/2FE interface 5/0 status