Specifications

Configuring the 12E/2FE Interfaces 6-23
Adding an Interface to a Bridge Group
Figure 6-11 Selecting an Interface
Step 1
After verifying that the desired bridge group is listed in the Bridge-Groups list box and
assigned to a Bridge-Group button, select the 12E/2FE interface you want to add, and
then select the Bridge-Group button.
In Figure 6-12, 12E/2FE interface 5/0 is added to bridge group 1.
Note To select multiple 12E/2FE interfaces, hold down the Shift key as you select each
interface.
Figure 6-12 Verifying an Added Interface
Step 2
Make sure the status line of the WebTool indicates that the interface was added to the
correct bridge group.
Step 3 Bring up the interface by selecting the administrative check box below the interface. (See
Figure 6-13.)
NM5538
12E/2FE interface 5/0 status
12E/2FE interface 5/0
Desired bridge group
NM5539
Selected 12E/2FE interface 5/0
Updated 12E/2FE
interface 5/0 status
Selected button