Specifications

Configuring Bridge Groups Using the 12E/2FE VLAN Configuration WebTool on the Cisco 7200 Series Routers
PA-12E/2FE Ethernet Switch 10BASE-T and 100BASE-TX Port Adapter Installation and Configuration
6-22
Step 2 After selecting the bridge group from the Bridge-Groups list box, select one of the
Bridge-Groups colored buttons.
The bridge group’s number is listed in the selected button, the status line of the WebTool
indicates that the colored button represents the new bridge group, and the color of the
button is applied to the bridge group’s 12E/2FE interfaces. (See Figure 6-10.)
Figure 6-10 Assigning a Color to the New Bridge Group
Step 3
Repeat Step 1 and Step 2 for additional bridge groups.
This completes the procedure for assigning a color to a new bridge group using the 12E/2FE VLAN
Configuration WebTool.
Adding an Interface to a Bridge Group
The following procedure explains how to add a 12E/2FE interface to a bridge group. Before adding
a 12E/2FE interface to a bridge group, make sure the desired bridge group is listed in the WebTool’s
Bridge-Groups list box and assigned to one of the Bridge-Groups colored buttons. See earlier
sections for instructions.
In Figure 6-11, bridge group 1 is listed in the Bridge-Groups list box and is assigned to the first
Bridge-Groups colored button.
Note Placing the cursor over a 12E/2FE interface displays the bridge group and administrative
status of the interface in the status line of the WebTool. In Figure 6-11, the first 12E/2FE interface
(FastEthernet5/0) is not assigned to a bridge group and is administratively down.
NM6408
Updated
button status
Selected button