Specifications

Configuring Bridge Groups Using the 12E/2FE VLAN Configuration WebTool on the Cisco 7200 Series Routers

PA-12E/2FE Ethernet Switch 10BASE-T and 100BASE-TX Port Adapter Installation and Configuration

6-20

Step 4 Select the hypertext link for an installed 12E/2FE port adapter. The browser launches the

WebTool for the selected 12E/2FE port adapter. (See Figure 6-3.)

Note The browser launches one WebTool for each selected 12E/2FE port adapter

hypertext link. You can launch only one WebTool at a time from the browser.

This completes the procedure for accessing the 12E/2FE VLAN Conﬁguration WebTool.

Creating a Bridge Group

Complete the following steps to create a new bridge group:

Step 1 In the WebTool, select the Create option from the Bridge-Group pull-down menu. (See

Figure 6-6.)

The Create New Bridge-Group dialog box appears. (See Figure 6-7.)

Figure 6-6 12E/2FE VLAN Conﬁguration WebTool Pull-Down Menu

Step 2

In the Create New Bridge-Group dialog box, enter the new bridge-group number and

select OK.

After entering the new bridge-group number and selecting OK, the status line of the

WebTool indicates that the new bridge group was created, and the new bridge-group

number is listed in the WebTool’s conﬁgured Bridge-Groups list box. (See Figure 6-8.)

Note The acceptable range of bridge-group numbers is from 1 to 63. The status line of

the WebTool will indicate if the number speciﬁed for the new bridge group is already in

use or is out of the acceptable range (1-63).

Figure 6-7 Create New-Bridge Group Dialog Box

MN5535

Bridge-Group pull-down menu