Specifications

Installing a Dual-Width Port Adapter
PA-12E/2FE Ethernet Switch 10BASE-T and 100BASE-TX Port Adapter Installation and Configuration
3-6
Figure 3-6 Aligning the Port Adapter Metal Carrier Between the Slot Guides
(Cisco 7206 Shown)
Step 5
With the metal carrier aligned in the slot guides, gently slide the port adapter halfway into
the slot.
Caution Do not slide the port adapter all the way into the slot until you have connected all required
cables. Trying to do so will disrupt normal operation of the router.
Step 6 With the port adapter halfway in the slot, connect all required cables to the port adapter.
Step 7 After connecting the cables, carefully slide the port adapter all the way into the slot until
the port adapter is seated in the router midplane.
Step 8 Move the port adapter lever for each port adapter slot to the locked position. (See
Figure 3-7.)
Note If the port adapter levers do not move to the locked position, the port adapter is not
completely seated in the midplane. Carefully pull the port adapter halfway out of the slot,
reinsert it, and move the port adapter levers to the locked position.
2
FAST SERIAL
EN
TD
TC
RD
RC
LB
CD
TD
TC
RD
RC
LB
CD
TD
TC
RD
RC
LB
CD
TD
TC
RD
RC
LB
CD
TOKEN RING
0
1
2
3
0
4
1
3
5
6
ETHERNET-10BFL
EN
RX
0
1
2
3
4
TX
RX
TX
RX
TX
RX
TX
RX
TX
ENABLED
PCMCIA
EJECT
SLOT 0
SLOT 1
FE MII
FAST ETHERNET INPUT/OUTPUT CONTROLLER
H10306
EN
0
LNK
ETHER SWITCH
Slot
guide
0
LNK
FDX
LNK
COL/FDX
3
LNK
COL/FDX
4
LNK
COL/FDX
5
LNK COL/FDX
6
LNK
COL/FDX
7
LNK
COL/FDX
8
LNK
COL/FDX
9
LNK COL/FDX
10
LNK
COL/FDX
LNK COL/FDX
12
LNK
COL/FDX
13
1
LNK
FDX
10/100
LNK
COL/FDX
2
10/100
MII
EN
RJ-45
EN
RJ-45
RJ-45
LINK
1O PWR
OK