Specifications

Removing a Port Adapter Slot Divider
PA-12E/2FE Ethernet Switch 10BASE-T and 100BASE-TX Port Adapter Installation and Configuration
3-4
Figure 3-3 Handling a Port Adapter
Step 6
Place the port adapter on an antistatic surface with its components facing upward, or in a
static shielding bag. If the port adapter will be returned to the factory, immediately place
it in a static shielding bag.
This completes the procedure for removing a single-width port adapter from a Cisco 7200 series
router.
Removing a Port Adapter Slot Divider
Following is the procedure for removing a port adapter slot divider from a Cisco 7200 series router:
Step 1 Remove installed single-width port adapters from the slots on both sides of the port
adapter slot divider. (See the “Removing a Single-Width Port Adapter” section on page
3-3 for instructions.)
Step 2 With one hand, raise the slot divider lever to unlock the slot divider from the chassis. (See
Figure 3-4.)
Figure 3-4 Slot Divider Lever (Cisco 7206 Shown)
Step 3
With the slot divider lever still raised, use your other hand to pull the slot divider from the
chassis. (See Figure 3-5.)
H6420
Metal carrier
Printed circuit board
H6434
2
4
6
1
3
5
Slot divider lever
0
MII
EN
RJ45
EN
RJ45
LINK
1O PWR
OK
RJ-45
CPU RESET
FAST ETHERNET INPUT/OUTPUT CONTROLLER
ENABLED
PCMCIA
EJECT
SLOT 0
SLOT 1
FE MII