Datasheet

Command Reference
PA-E3 and PA-2E3 Serial Port Adapter 9
international bit
To set the E3 international bit in the G.751 frame used by the PA-E3 port adapter, use the
international bit interface configuration command. To return to the default international bit, use the
no form of this command.
international bit {0 | 1} {0 | 1}
no international bit
Syntax Description
Default
0 0 international bit
Command Mode
Interface configuration
Usage Guidelines
This command first appeared in Cisco IOS Release 11.1 CA.
The international bit command sets bits 6 and 8 respectively of set II in the E3 frame.
To verify the international bit configured on the interface, use the show controller serial EXEC
command.
Example
The following example sets the international bit to 1 1 on the PA-E3 port adapter in slot 1,
port-adapter slot 0, interface 0:
interface serial 1/0/0
international bit 1 1
Related Commands
national bit
show controllers serial
0 | 1 Specifies the value of the first international bit in the G.751 frame. The
default is 0.
0 | 1 Specifies the value of the second international bit in the G.751 frame.
The default is 0.