Datasheet

8 Release 11.1 CA
Command Reference
framing
To specify E3 line framing used by the PA-E3 port adapter, use the framing interface configuration
command. To return to the default G.751 framing, use the no form of this command.
framing {bypass | g751}
no framing
Syntax Description
Default
G.751 framing
Command Mode
Interface configuration
Usage Guidelines
This command first appeared in Cisco IOS Release 11.1 CA.
The default framing is described in the ITU-T Recommendation G.751.
Note The ITU-T carries out the functions of the former Consultative Committee for International
Telegraph and Telephone (CCITT).
When the framing mode is bypass, the E3 frame data is not included in the E3 frame, just the data.
To verify the framing mode configured on the interface, use the show controller serial EXEC
command.
Example
The following example sets the framing mode to bypass on interface 1/0/0:
interface serial 1/0/0
framing bypass
Related Command
show controllers serial
bypass Specifies bypass E3 framing.
g751 Specifies G.751 E3 framing. This is the default.