Datasheet

6 Release 11.1 CA
Command Reference
dsu bandwidth
To specify the maximum allowable bandwidth used by the PA-E3 port adapter, use the dsu
bandwidth interface configuration command. To return to the default bandwidth, use the no form
of this command.
dsu bandwidth kbps
no dsu bandwidth
Syntax Description
Default
34010 kbps
Command Mode
Interface configuration
Usage Guidelines
This command first appeared in Cisco IOS Release 11.1 CA.
The local interface configuration must match the remote interface configuration. For example, if you
reduce the maximum bandwidth to 16000 on the local port, you must also do the same on the remote
port.
The dsu bandwidth command reduces the bandwidth by padding the E3 frame.
To verify the data service unit (DSU) bandwidth configured on the interface, use the show controller
serial EXEC command.
Example
The following example sets the DSU bandwidth to 16000 kbps on interface 1/0/0:
interface serial 1/0/0
dsu bandwidth 16000
Related Command
show controllers serial
kbps Maximum bandwidth in the range of 22 kbps to 34010 kbps. The
default is 34010 kbps.