Specifications

3-44
Cisco ONS 15454 and Cisco ONS 15327 TL1 Command Guide, R3.3
May 2002
Chapter 3 TL1 Command Descriptions
TL1 Commands
3.5.17 ED-<OCN_TYPE>: Edit (OC3, OC12, OC48, OC192)
(OC192 supported for Cisco ONS 15454 only)
This command edits the attributes (i.e. service parameters) and state of an OC-N facility. Allowable
states for a facility are Out of Service (OOS) and In Service (IS).
The DCC transmit is bridged to both working and protect in a 1+1 configuration. On the receive side,
the active one is selected for DCC. The DCC is provisioned on the working port only in a 1+1
configuration.
All OCN lines are allowed to change to SDH mode with this command with the following restrictions:
1. The line must be unprotected at the time, but can be protected after changing.
2. The line can be a sync reference but cannot have “syncMessages” enabled or “send Do Not Use”.
3. The line cannot have Orderwire.
4. The line cannot have VT circuits.
5. The line cannot have DCC.
All lines in a 1+1 or BLSR must have the same mode. If the mode of a line that is in a 1+1 or BLSR is
changed, an error message will be returned.
Section DLT-USER-SECU Description
Category Security
Security Superuser
Related
Messages
ACT-USER
CANC
CANC-USER
ED-PID
ED-USER-SECU
ENT-USER-SECU
REPT EVT SECU
Input Format DLT-USER-SECU:[<TID>]:<UID>:<CTAG>;
where:
• <UID> is the user identifier and is a string; <UID> is any combination of up to
10 alphanumeric characters.
Note CTC allows <UID> and <PID> of up to 20 characters. The 20 character
CTC-entered <UID> and <PID> are not valid TL1 <UID> and <PID>.
Input Example DLT-USER-SECU:PETALUMA:CISCO15:123;
Errors This message generates all the default errors
Section ED-<OCN_TYPE> Description
Category Ports
Security Provisioning