Specifications

3-42
Cisco ONS 15454 and Cisco ONS 15327 TL1 Command Guide, R3.3
May 2002
Chapter 3 TL1 Command Descriptions
TL1 Commands
3.5.14 DLT-EQPT: Delete Equipment
This command deletes a card from a slot in the NE.
This command removes the card type and attributes that were entered for a particular slot. If any facilities
are assigned, they are deleted too. The command will be denied if the card is part of a protection group
or has a cross-connect end-point.
To delete a card that is part of a protection group, it has to be removed from the protection group first
via ED-EQPT.
Error conditions for deleting equipment may be:
1. For a card in a protection group that has a cross connection, DCC or is a synchronization source, the
SPLD (Equipment in use) error message will be returned.
2. If a card is not provisioned, an error message will be returned.
Input Format DLT-CRS-VT1:[<TID>]:<FROM>,<TO>:<CTAG>[:::];
where:
• <FROM> indicates an identifier at one end of the VT cross connection;
<FROM> is the AID from the “VT1_5” section on page 4-17.
• <TO> indicates an identifier at the other end of the VT cross connection; <TO>
is the AID from the “VT1_5” section on page 4-17.
Input Example DLT-CRS-VT1:CISCO:VT1-2-3-7-2,VT1-4-4-5-2:1234;
Errors This message generates all the default errors
Section DLT-CRS-VT1 Description (continued)
Section DLT-EQPT Description
Category Equipment
Security Provisioning
Related
Messages
ALW-SWDX-EQPT REPT ALM EQPT
ALW-SWTOPROTN-EQPT REPT EVT EQPT
ALW-SWTOWKG-EQPT RTRV-ALM-EQPT
ED-EQPT RTRV-COND-EQPT
ENT-EQPT RTRV-EQPT
INH-SWDX-EQPT SW-DX-EQPT
INH-SWTOPROTN-EQPT SW-TOPROTN-EQPT
INH-SWTOWKG-EQPT SW-TOWKG-EQPT
Input Format DLT-EQPT:[<TID>]:<AID>:<CTAG>[:::];
where:
• <AID> is the equipment unit (slot) to act on and is the AID from the “EQPT”
section on page 4-11.
Input Example DLT-EQPT:SONOMA:SLOT-1:104;
Errors This message generates all the default errors