Specifications

3-38
Cisco ONS 15454 and Cisco ONS 15327 TL1 Command Guide, R3.3
May 2002
Chapter 3 TL1 Command Descriptions
TL1 Commands
3. If a requested TAP does not exist, a RTEN error message will be returned.
4. If a circuit is already connected to another TAP, a SCAT error message will be returned.
5. If a requested condition already exists, a SRCN error message will be returned.
6. If the AID is invalid, a IIAC (Input, Invalid Access Identifier) error message will be returned.
7. If an access is not supported, an EANS error message will be returned.
8. If a requested access configuration is invalid, a SRAC error message will be returned.
Section CONN-TACC-<MOD_TACC> Description
Category Test Access
Security Provisioning
Related
Messages
CHG-ACCMD-<CHG-ACCMD>
DISC-TACC
Input Format CONN-TACC-<MOD_TACC>:[<TID>]:<AID>:<CTAG>::[<TAP>]:MD=<MD>;
where:
<AID> is an access identifier. <AID> format is the modifier AID format in the
ALL AID list. <AID> is the AID from the ALL” section on page 4-5. <AID>
must not be null.
<TAP> indicates the test access path number selected by the NE. The <TAP> is
used to identify all messages between the TSC and the NE until the access path
is released. The <TAP> number must be an integer with a range of 1 to 999. A
null <TAP> defaults to an appropriate <TAP> number selected by the NE.
<TAP> is an integer and a null value is equivalent to ALL.
<MD> indicates the test access mode (SPLTE, SPLTF, LOOPE and LOOPF
require an external QRS input signal); valid values for <MD> are shown in the
“TACC_MODE” section on page 4-62. <MD> must not be null.
Input Example CONN-TACC-STS1:CISCO:STS-2-4:123::8:MD=MONE;
Output Format SID DATE TIME
M CTAG COMPLD
“<TAP>”
;
where:
<TAP> indicates the test access path number selected by the NE. The <TAP> is
used to identify all messages between the TSC and NE until the access path is
released. The <TAP> number must be an integer with a range of 1 - 999. A null
<TAP> defaults to an appropriate <TAP> number selected by the NE. <TAP> is
an integer.
Output
Example
TID-000 1998-06-20 14:30:00
M 001 COMPLD
“8”
;
Errors This message generates all the default errors