Specifications

3-35
Cisco ONS 15454 and Cisco ONS 15327 TL1 Command Guide, R3.3
May 2002
Chapter 3 TL1 Command Descriptions
TL1 Commands
3.5.7 CANC: Cancel
Reports the occurrence of a session timeout event.
CANC is an autonomous message transmitted by the NE to a user when a session established by that user
is terminated because no messages were exchanged for a long period of time, a timeout. The timeout
period is set based on the user’s privilege. The superuser [SUPER] has the timeout period of 15 minutes.
The Provision user [PROV] has the timeout period of 30 minutes. The Maintenance [MAINT] user has
the timeout period of 60 minutes.
When a timeout occurs, the corresponding port drops and the next session initiation at that port requires
the regular login procedure.
Section ALW-SWTOWKG-EQPT Description
Category Equipment
Security Maintenance
Related
Messages
ALW-SWDX-EQPT REPT ALM EQPT
ALW-SWTOPROTN-EQPT REPT EVT EQPT
DLT-EQPT RTRV-ALM-EQPT
ED-EQPT RTRV-COND-EQPT
ENT-EQPT RTRV-EQPT
INH-SWDX-EQPT SW-DX-EQPT
INH-SWTOPROTN-EQPT SW-TOPROTN-EQPT
INH-SWTOWKG-EQPT SW-TOWKG-EQPT
Input Format ALW-SWTOWKG-EQPT:[<TID>]:<AID>:<CTAG>[::<DIRN>];
where:
• <AID> This parameter can either be the protection unit for which switching back
to working is to be allowed (release of lock on) or the working unit for which
carrying traffic is to be allowed (release of lockout); <AID> is from the “EQPT”
section on page 4-11.
• <DIRN> is the direction of the switching. The command only supports one value
of the <DIRN> parameter - BTH. This parameter defaults to BTH; valid values
for <DIRN> are shown in the “DIRECTION” section on page 4-35.
Input Example ALW-SWTOWKG-EQPT:CISCO:SLOT-2:123::BTH;
Errors This message generates all the default errors
Section CANC Description
Category Security
Security Retrieve
Related
Messages
ACT-USER
CANC-USER
DLT-USER-SECU
ED-PID
ED-USER-SECU
ENT-USER-SECU
REPT EVT SECU