Specifications

3-32
Cisco ONS 15454 and Cisco ONS 15327 TL1 Command Guide, R3.3
May 2002
Chapter 3 TL1 Command Descriptions
TL1 Commands
3.5.3 ALW-MSG-DBCHG: Allow Database Change Message
This command is used to enable REPT DBCHG.
Note This command is not defined in the GR.
3.5.4 ALW-SWDX-EQPT: Allow Switch Duplex Equipment
(Cisco ONS 15454 only)
This command instructs an NE to allow automatic or manual switching on a duplex system containing
duplexed or redundant equipment. To inhibit an NE switching to duplex, use the INH-SWDX-EQPT
command.
ALW-SWDX-EQPT is not used for SONET line or electrical card protection switching. For SONET line
or path protection switching commands, see OPR-PROTNSW and RLS-PROTNSW commands. For the
electrical card protection switching, see SW-TOWKG-EQPT and SW-TOPROTN-EQPT commands.
Note This command applies to the XC or XCVT equipment unit only in this release.
Section ALW-MSG-DBCHG Description
Category Log
Security Retrieve
Related
Messages
INH-MSG-DBCHG
REPT DBCHG
RTRV-LOG
Input Format ALW-MSG-DBCHG:[<TID>]::<CTAG>[::,,];
Input Example ALW-MSG-DBCHG:CISCO::123;
Errors This message generates all the default errors
Section ALW-SWDX-EQPT Description
Category Equipment
Security Maintenance
Related
Messages
ALW-SWTOPROTN-EQPT REPT ALM EQPT
ALW-SWTOWKG-EQPT REPT EVT EQPT
DLT-EQPT RTRV-ALM-EQPT
ED-EQPT RTRV-COND-EQPT
ENT-EQPT RTRV-EQPT
INH-SWDX-EQPT SW-DX-EQPT
INH-SWTOPROTN-EQPT SW-TOPROTN-EQPT
INH-SWTOWKG-EQPT SW-TOWKG-EQPT
Input Format ALW-SWDX-EQPT:[<TID>]:<AID>:<CTAG>[::];
where:
• <AID> is the XC/XCVT equipment AID from the “EQPT” section on page 4-11