Specifications

1-15
Cisco ONS 15454 and Cisco ONS 15327 TL1 Command Guide, R3.3
May 2002
Chapter 1 Getting Started
Test Access
Note The <AID> provided designates the E side and the other automatically becomes the F side. Once a
CONN-TACC is set up, these designations cannot change until a DISC-TACC or another CONN-TACC
command is executed. The connection is based on the <AID> supplied.
1.8.7 Changing Test Access Modes
The command to change a TACC mode is:
Example 1-5 CHG-ACCMD-STS1:CISCO:8:123::MONF;
This command changes the test access mode for the circuit under test.This may be a change from
monitoring the data to inserting data into the STS. This command can only be applied to an existing TAP
connection. STS192c is not supported for Cisco ONS 15327.
1.8.8 Disconnecting Test Access Modes
TAPs can be disconnected in the following ways:
• Issue the DISC-TACC command
• Delete or modify accessed connection
• Drop the TL1 session for any reason, including logout or a dropped telnet session
• Switch or reset a TCC+/XTC
1.8.9 Deleting Test Access Points
The command to delete a TAP is:
Example 1-6 ED-<STS_PATH>:[<[TID>]:<AID>:<CTAG>:::TACC=0:;
Note The TACC number must be set to zero in order to delete a TAP.
Note If a TAP is not removed the STS bandwidth will be stranded.