Specifications

1-9
Cisco ONS 15454 and Cisco ONS 15327 TL1 Command Guide, R3.3
May 2002
Chapter 1 Getting Started
Test Access
1.7.2.3 Explicit List Grouped With Implicit List
When you have determined the implicit list, apply the rules from the “Implicit List of AIDs - Single AID
With Wildcard” section on page 1-8 to the implicit list and the rules from the “Explicit List of AIDs -
No Wildcards” section on page 1-8 to the explicit list. Apply the following logic to the results from the
two subsets:
1. Explicit list returns CMPLD, implicit list returns CMPLD, return CMPLD plus matching list
2. Explicit list returns CMPLD, implicit list returns DENY, return PRTLwith errors plus matching list
3. Explicit list returns PRTL, implicit list returns CMPLD, return PRTL with errors plus matching lists
4. Explicit list returns PRTL, implicit list returns DENY, return PRTL with errors plus matching list
5. Explicit list returns DENY, implicit list returns CMPLD, return PRTL with errors plus matching list
6. Explicit list returns DENY, implicit list returns DENY, return DENY with errors
1.8 Test Access
TL1 Test Access enables you to monitor and test circuits. Commands to connect, disconnect, and change
the test access (TACC) and test access connections have been added to TL1 starting with ONS 15454
R3.0. This section includes test access configurations, mode definitions, split access modes, and loop
modes. You can view test access information in CTC; in node view click the Maintenance > Test Access
tabs.
Refer to Telcordia document GR-834-CORE, Network Maintenance: Access and Testing and
GR-1402-CORE, Network Maintenance: Access Testing - DS3 HCDS TSC/RTU and DTAU Functional
Requirements for more information about Test Access. See Chapter 3, “TL1 Command Descriptions” for
TL1 command information.
Figure 1-2 Single node view (Node 1)
RTU
E
F
Test Set
71716