Specifications

7-14
Cisco ONS 15454 and Cisco ONS 15327 TL1 Command Guide, R3.3
May 2002
Chapter 7 TL1 Alarms and Errors
Errors
SATF STATUS Automatic Test Failed
SCAT STATUS Circuit is Already Connected to Another Tap
SCBS STATUS Channel Busy
SCIS STATUS Circuit in Split Condition
SCNA STATUS Command Not Able to be Aborted
SCNF STATUS Command Not Found
SCNS STATUS Circuit Not in Split Condition
SCOS STATUS Channel Out-of-Service
SCSD STATUS Can't Split DS0B Circuit
SCSN STATUS Invalid Command Sequence
SDAS STATUS Diagnosis Already Started
SDBE STATUS Internal Data Base Error
SDFA STATUS Duplex Unit Failed
SDLD STATUS Duplex Unit Locked
SDNA STATUS Dumple Unit Not Available
SDNC STATUS Input Data is Not Consistent With NE Data
SDNR STATUS Data Not Ready
SDNS STATUS Diagnosis Not Started Yet
SEOS STATUS NTE is Out-of-Service
SFAS STATUS Fault Locating Already Started
SFNS STATUS Fault Locating Not Started yet
SFYA STATUS Facility Reports Amber Alarm
SLNS STATUS Log Not Started Yet
SLOS STATUS TSC to RTU Link Out-of-Service
SNCC STATUS Not Cross-Connected
SNCN STATUS NTE Unable to Execute Command
SNDS STATUS NTE is in a Diagnostic State
SNIM STATUS NTE Access Complete, Circuit was in Monitor State
SNIS STATUS Not in Service
SNML STATUS No Monitor Line Established
SNNB STATUS NTE Could Not Sync on DS0B Signal
SNNS STATUS NTE Could Not Sync on DS-1 Signal
SNOS STATUS NTE is Out-of-Service
SNPR STATUS Not in Protection State
SNRM STATUS System Not in Restoration Mode
Table 7-21 Error Codes (continued)
Error Code
(ERRCDE) Error Type Error Message (ERRMSG)