Specifications

7-11
Cisco ONS 15454 and Cisco ONS 15327 TL1 Command Guide, R3.3
May 2002
Chapter 7 TL1 Alarms and Errors
Errors
7.2 Errors
Errors may be generated by any command or command response message. The format of an error
message is as follows:
SID DATE TIME
M CTAG DENY
<ERRCDE>
/* <ERRMSG> */
;
Table 7-21 Error Codes
Error Code
(ERRCDE) Error Type Error Message (ERRMSG)
EANS EQUIPAGE Access Not Supported
EATN EQUIPAGE Not Valid for Access Type
EFON EQUIPAGE Feature Option not Provided
EN2T EQUIPAGE Not 2-wire Terminate and Leave
ENAC EQUIPAGE Not Equipped with Alarm Cutoff
ENAD EQUIPAGE Not Equipped with Audit Capability
ENAR EQUIPAGE Not Equipped with Automatic Reconfiguration
ENAT EQUIPAGE Request Not Valid for Access Type
ENDG EQUIPAGE Not Equipped with Diagnostic Capability
ENDS EQUIPAGE Not Equipped with Duplex Switching
ENEA EQUIPAGE Not Equipped with Error Analysis Capability
ENEQ EQUIPAGE Not Equipped
ENEX EQUIPAGE Not Equipped with Exercise Capability
ENFE EQUIPAGE Feature not Provided
ENFL EQUIPAGE Not Equipped for Fault Locating
ENHN EQUIPAGE Not Hybrid Network
ENMB EQUIPAGE Not Multipoint Bridge
ENMD EQUIPAGE Not Equipped with Memory Device
ENPM EQUIPAGE Not Equipped for Performance Monitoring
ENPS EQUIPAGE Not Equipped with Protection Switching
ENRE EQUIPAGE Not Recognized Equipage
ENRI EQUIPAGE Not Equipped for Retrieving Specified Information
ENRS EQUIPAGE Not Equipped for Restoration
ENSA EQUIPAGE Not Equipped for Scheduling Audit
ENSG EQUIPAGE Not Software Generic
ENSI EQUIPAGE Not Equipped for Setting Specified Information
ENSS EQUIPAGE Not Equipped with Synchronization Switching