Specifications

5-9
Cisco ONS 15454 and Cisco ONS 15327 TL1 Command Guide, R3.3
May 2002
Chapter 5 Ring Provisioning
1WAY Drop and Continue
5.4 1WAY Drop and Continue
The following examples show how to create a 1WAY drop and continue cross-connect. The examples
use three nodes (Node 1, Node 2, and Node 3) in a ring configuration. Node 1 is the source node, Node 2
has the drop and continue, and Node 3 is the destination.
Figure 5-19 1WAY drop and continue
5.4.1 Sample Node 1 Configuration (Source Node)
Issue the ENT-CRS-STSn::STS-1-1,STS-5-1&STS-6-1:CTAG::1WAY; command on this Node 1.
Figure 5-20 Bridge from 1/1/1 to 5/1/1 and 6/1/1
6/1/1
East
5/1/1
West
6/1/1
East
5/1/1
West
6/1/1
East
5/1/1
West
1/1/1
Source Node
1/1/1
Drop and Continue Node
1/1/1
Destination Node
Node 2 Node 3
Node 1
61315
61313
1/1/1
Rx
6/1/1
Tx
5/1/1
Tx
Bridge