Specifications

4-30
Cisco ONS 15454 and Cisco ONS 15327 TL1 Command Guide, R3.3
May 2002
Chapter 4 TL1 Command Components
Parameter Types
MANWKBK-R Manual Switch of working facility/equipment to protection - Ring
MANWKBK-S Manual Switch of working facility/equipment to protection - Span
MANWKPR-R Manual Switch of Working facility/equipment to Protection unit -Ring
MANWKPR-S Manual Switch of Working facility/equipment to Protection unit
-Span
MANWKSWBK Recovery action - Manual Switch of working facility/equipment to
protection
MANWKSWPR Recovery action - Manual Switch of Working facility/equipment to
Protection unit
MANWKSWPR-PATH Manual Switch of working facility/equipment to Protection - Path
MEA Internal error - Mismatch of Equipment and Attributes
MEM-GONE Software operations exceed the memory capacity of the TCC/TCC+
card
MEM-LOW Data generated by software operations is close to exceeding the
memory capacity of the TCC/TCC+ card
MFGMEM Manufacturing Data Memory (EEPROM) Failure
NEW-ROOT NewRoot trap in BRIDGE-MIB
NORMAL Normal condition. This condition type is used by the NE to report the
returning to normal from a previous off-normal condition
OG External failure - Outgoing failure condition
OOF External failure - Incoming - Out of Frame
PATHSEL External failure - Incoming - Path Selector inability to switch to a
valid signal
PDI External failure - Incoming - Signal Label Mismatch Failure - Payload
Defect Indication
PDI-P External failure - Incoming - Signal Label Mismatch Failure - Payload
Defect Indication - Path
PEER-MISM Peer State Mismatch
PEER-NORESPONSE Peer card not responding
PLM-P External failure - Incoming - Signal Label Mismatch Failure - Payload
Label Mismatch - Path
PLM-V Content of the V5 byte in the SONET overhead is inconsistent or
invalid
PLUG-IN Internal hardware - Equipment unit plug-in
PM-TCA Performance Monitoring - Threshold Crossing Alert
PRC-DUPID Procedural Error - Duplicate Node ID
PRCDRERR Procedural Error
PROGFLT Internal Error - Software Fault - Program failure
PROTNA Protection unit not available
Table 4-46 CONDITION Values (continued)
CONDITION Values Description