Specifications

3-168
Cisco ONS 15454 and Cisco ONS 15327 TL1 Command Guide, R3.3
May 2002
Chapter 3 TL1 Command Descriptions
TL1 Commands
3.5.118 RTRV-T3: Retrieve T3
This command retrieves the facility properties of a DS3 and a DS3XM card.
(The facilities are on the XTC card for the ONS 15327)
Notes:
1. CTC can set the FMT attribute of a DS3(N)E line to autoprovision to set the framing based on the
framing is coming in. This would result in the FMT field being blanked out for a few seconds
blanked forever for a preprovisioned DS3(N)E card on CTC.
2. The autoprovision is not considered a valid DS3 framing type. It is used only to trigger an autosense
and subsequent autoprovisioning of a valid DS3 framing type (unframed, M23, C-BIT).
3. TL1 does not have the autoprovision mode according to GR-199. TL1 maps/returns the
autoprovision to be the unframed framing type.
Output Format SID DATE TIME
M CTAG COMPLD
“<AID>::[LINECDE=<LINECDE>,][FMT=<FMT>,]
[LBO=<LBO>,][TACC=<TACC>]:[<PST>]”
;
where:
• <AID> is the access identifier from the “FACILITY” section on page 4-11
• <LINECDE> is the line code; valid values for <LINECDE> are shown in the
“LINE_CODE” section on page 4-42, <LINECDE> is optional
• <FMT> is the frame format; valid values for <FMT> are shown in the
“FRAME_FORMAT” section on page 4-41, <FMT> is optional
• <LBO> is the line buildout; valid values for <LBO> are shown in the
“LINE_BUILDOUT” section on page 4-42, <LBO> is optional
• <TACC> defines the STS as a test access port with a selected unique TAP
number. The TAP number ranges from 1–999; <TACC> is an integer and is
optional.
• <PST> is the state; valid values for <PST> are shown in the “PST” section on
page 4-53, <PST> is optional
Output
Example
TID-000 1998-06-20 14:30:00
M 001 COMPLD
“FAC-2-1::LINECDE=AMI,FMT=ESF,LBO=0-131,TACC=8:OOS”
;
Errors This message generates all the default errors
Section RTRV-T1 Description (continued)
Section RTRV-T3 Description
Category Ports
Security Retrieve