Specifications

3-166
Cisco ONS 15454 and Cisco ONS 15327 TL1 Command Guide, R3.3
May 2002
Chapter 3 TL1 Command Descriptions
TL1 Commands
3.5.116 RTRV-SYNCN: Retrieve Synchronization
This command retrieves the synchronization reference list used to determine the sources for the NE's
reference clock and the BITS output clock. For each clock, up to three synchronization sources may be
specified (e.g. PRIMARY, SECOND, THIRD).
Notes:
1. To retrieve/set the timing mode, SSM message Set or Quality of RES information, use the
RTRV-NE-SYNCN and ED-NE-SYNCN commands.
2. The output example shown here is under line timing mode.
Section RTRV-SYNCN Description
Category Synchronization
Security Retrieve
Related
Messages
ED-BITS RLS-SYNCNSW
ED-NE-SYNCN RTRV-ALM-BITS
ED-SYNCN RTRV-ALM-SYNCN
OPR-SYNCNSW RTRV-BITS
REPT ALM BITS RTRV-COND-BITS
REPT ALM SYNCN RTRV-COND-SYNCN
REPT EVT BITS RTRV-NE-SYNCN
REPT EVT SYNCN
Input Format RTRV-SYNCN:[<TID>]:<AID>:<CTAG>[::::];
where:
• <AID> identifies the synchronization reference to retrieve; <AID> is from the
“SYNC_REF” section on page 4-15, is listable and must not be null
Input Example RTRV-SYNCN:BOYES:SYNC-NE:234;
Output Format SID DATE TIME
M CTAG COMPLD
“<AID>:<REF>,<REFVAL>,[<QREF>],[<STATUS>]”
;
where:
• <AID> is the synchronization reference to be modified and is from the
“SYNC_REF” section on page 4-15
• <REF> is the rank of the synchronization reference and is the AID from the
“SYNCSW” section on page 4-16
• <REFVAL> is the value of the synchronization reference and is the AID from
the “SYN_SRC” section on page 4-14
• <QREF> is the quality of the RES; valid values for <QREF> are shown in the
“SYNC_QUALITY_LEVEL” section on page 4-61, <QREF> is optional
• <STATUS> is the active status of the synchronization source; valid values for
<STATUS> are shown in the “STATUS” section on page 4-57, <STATUS> is
optional