Specifications

3-163
Cisco ONS 15454 and Cisco ONS 15327 TL1 Command Guide, R3.3
May 2002
Chapter 3 TL1 Command Descriptions
TL1 Commands
3.5.114 RTRV-PMMODE-<STS_PATH>: Retrieve Performance Mode of PM Data
Collection (STS1, STS3C, STS6C, STS9C, STS12C, STS24C, STS48C, STS192C)
(STS192C supported for ONS 15454 only)
This command instructs a SONET NE to send the type of PM mode that has been previously set in the
NE. This command can be used to identify whether the PM parameters are Section, Line or Path type,
and to identify whether or not the PM are being collected by the NE.
This command returns the categories that are enabled only.
The PM mode and state of an entity is set by using the SET-PMMODE command.
Notes:
1. This near end monitoring of the intermediate-path PM (IPPM) only supports OC-3, OC-12, OC-48,
OC-48AS, OC-192, and EC-1 on STS Path.
2. The far end PM data collection is not supported by the current ONS 15454 in this release.
3. This release of software will support only the Path (P) mode type PM parameters with this
command, that is, this command will not be applicable for Line (L) and Section (S) mode types. It
should be noted that the PM monitoring for Line (L) and Section (S) are supported by the ONS
15454, and the storing PM data is always performed.
4. This command only returns the categories that are enabled (pmstate is ON), and does not return the
categories that are disabled (pmstate is OFF).
Section RTRV-PMMODE-<STS_PATH> Description
Category Performance
Security Retrieve
Related
Messages
INIT-REG-<MOD2>
RTRV-PM-<MOD2>
RTRV-TH-<MOD2>
SET-PMMODE-<STS_PATH>
SET-TH-<MOD2>
Input Format RTRV-PMMODE-<STS_PATH>:[<TID>]:AID>:<CTAG>::<LOCN>;
where:
• <AID> identifies the entity from where the PM mode is being retrieved; <AID>
is from the “STS” section on page 4-12 and must not be null
• <LOCN> identifies the location from where the PM mode is being retrieved and
valid values for <LOCN> are shown in the “LOCATION” section on page 4-42;
<LOCN> must not be null
Input Example RTRV-PMMODE-STS1:CISCO:STS-4-2:123::NEND;