Specifications

3-150
Cisco ONS 15454 and Cisco ONS 15327 TL1 Command Guide, R3.3
May 2002
Chapter 3 TL1 Command Descriptions
TL1 Commands
3.5.104 RTRV-EXT-CONT: Retrieve External Control
This command instructs the NE to report the control state of an external control. The command can be
used to audit the result of an OPR-EXT-CONT or a RLS-EXT-CONT command.
Notes:
1. If the CONTTYPE is null, the existing conttype on this AID will be returned.
2. The duration is not supported, it defaults to CONTS.
Section RTRV-EXT-CONT Description
Category Environmental Alarms and Controls
Security Retrieve
Related
Messages
OPR-EXT-CONT RTRV-ATTR-CONT
REPT ALM ENV RTRV-ATTR-ENV
REPT EVT ENV RTRV-COND-ENV
RLS-EXT-CONT SET-ATTR-CONT
RTRV-ALM-ENV SET-ATTR-ENV
Input Format RTRV-EXT-CONT:[<TID>]:<AID>:<CTAG>[::<CONTTYPE>];
where:
• <AID> is the access identifier from the “ENV” section on page 4-10 and must
not be null.
Note For ONS 15327, only ENV-OUT-{1-2} is a valid AID for RTRV-EXT-CONT.
Note For ONS 15454, only ENV-OUT-{1-4} and ENV-OUT-ALL are valid AIDs
for RTRV-EXT-CONT.
• <CONTTYPE> is from the “CONTTYPE” section on page 4-34. A null value is
equivalent to ALL.
Input Example RTRV-EXT-CONT:CISCO:ENV-OUT-2:123::AIRCOND;
Output Format SID DATE TIME
M CTAG COMPLD
“<AID>:[<CONTTYPE>],<DUR>,[<CONTSTATE>]”
;
where:
• <AID> identifies the external control for which control state is being retrieved
and is from the “ENV” section on page 4-10
• <CONTTYPE> is the type of control for which control state is being retrieved;
valid values for <CONTTYPE> are shown in the “CONTTYPE” section on
page 4-34, <CONTTYPE> is optional
• <DUR> is the duration for which the external control can be operated; valid
values for <DUR> are shown in the “DURATION” section on page 4-36
• <CONTSTATE> is the control of the external control; valid values for
<CONTSTATE> are shown in the “CONT_MODE” section on page 4-34,
<CONTSTATE> is optional