Specifications

3-148
Cisco ONS 15454 and Cisco ONS 15327 TL1 Command Guide, R3.3
May 2002
Chapter 3 TL1 Command Descriptions
TL1 Commands
3.5.103 RTRV-EQPT: Retrieve Equipment
This command retrieves the data and state parameters associated with an equipment unit.
This command returns the PRTYPE, PROTID, RVTM and RVRTV parameters for a card inside of a
protection group by the following scenario:
1. A working AID/card within a 1:1 protection group, the PRTYPE, PROTID, RVTM and RVRTV
attributes will be displayed.
2. A protection AID/card within 1:1 protection group, the PRTYPE, RVTM and RVRTV attributes will
be displayed.
3. A working AID/card within 1:N protection group, the PRTYPE, PROTID, RVTM and RVRTV=Y
attributes will be displayed.
4. A protection AID/card within 1:1 protection group, the PRTYPE, RVTM and RVRTV=Y attributes
will be displayed.
5. An unprotected AID/card, the AIDtype, equip (equip/unequip), status (act/standby), and state
(IS/OOS).
Error conditions:
1. The equipment is not provisioned.
Section RTRV-EQPT Description
Category Equipment
Security Retrieve
Related
Messages
ALW-SWDX-EQPT INH-SWTOWKG-EQPT
ALW-SWTOPROTN-EQPT REPT ALM EQPT
ALW-SWTOWKG-EQPT REPT EVT EQPT
DLT-EQPT RTRV-ALM-EQPT
ED-EQPT RTRV-COND-EQPT
ENT-EQPT SW-DX-EQPT
INH-SWDX-EQPT SW-TOPROTN-EQPT
INH-SWTOPROTN-EQPT SW-TOWKG-EQPT
Input Format RTRV-EQPT:[<TID>]:<AID>:<CTAG>[::::];
where:
• <AID> is the access identifier from the “EQPT” section on page 4-11 and must
not be null.
Input Example RTRV-EQPT:MIRABEL:SLOT-12:230;