Specifications

3-145
Cisco ONS 15454 and Cisco ONS 15327 TL1 Command Guide, R3.3
May 2002
Chapter 3 TL1 Command Descriptions
TL1 Commands
If retrieved on point f1 or f2, the output will be:
“f1&f2,s1&s2:CCT”
If retrieved on selector s1 or s2, the output will be:
“s1&s2,f1&f2:CCT”
2. All a&b AIDs in the TL1 cross connection command are in the format of WorkingAid&ProtectAid
3. Both 1WAYPCA and 2WAYPCA is used to specify a PCA cross connection.
Section RTRV-CRS-VT1 Description
Category Cross Connections
Security Retrieve
Related
Messages
DLT-CRS-<STS_PATH>
DLT-CRS-VT1
ENT-CRS-<STS_PATH>
ENT-CRS-VT1
RTRV-CRS-<STS_PATH>
Input Format RTRV-CRS-VT1:[<TID>]:<aid>:<CTAG>[::::];
where:
• <AID> identifies VT to check for connection membership. <AID> can be
Facility, VT or ALL. The ALL AID defaults to NE which reports all the existing
cross connections of the NE. <AID> is from the “ALL” section on page 4-5 and
must not be null.
Input Example RTRV-CRS-VT1:CISCO:VT1-1-1-1-1:1234;
Output Format SID DATE TIME
M CTAG COMPLD
“<FROM>,<TO>:<CCT>”
;
where:
• <FROM> indicates an identifier at one end of the VT cross connection and is the
AID from the “VT1_5” section on page 4-17
• <TO> indicates an identifier at the other end of the VT cross connection and is
the AID from the “VT1_5” section on page 4-17
• Valid values for <CCT> are shown in the “CCT” section on page 4-23
Output
Example
TID-000 1998-06-20 14:30:00
M 001 COMPLD
“VT1-1-1-1-1,VT1-4-4-5-2:1WAY”
;
Errors This message generates all the default errors