Specifications
3-138
Cisco ONS 15454 and Cisco ONS 15327 TL1 Command Guide, R3.3
May 2002
Chapter 3 TL1 Command Descriptions
TL1 Commands
Input Format RTRV-COND-EQPT:[<TID>]:<AID>:<CTAG>::[<TYPEREQ>][,,,];
where:
• <AID> is an identifier that has an alarm condition; <AID> is from the “EQPT”
section on page 4-11 and must not be null
• <TYPEREQ> is the type of condition to be retrieved; valid values for
<TYPEREQ> are shown in the “CONDITION” section on page 4-24. A null
value is equivalent to ALL.
Input Example RTRV-COND-EQPT:TID:SLOT-1:229::LOS;
Output Format SID DATE TIME
M CTAG COMPLD
“<AID>,[<AIDTYPE>]:[<NTFCNCDE>],<TYPEREQ>,[<SRVEFF>],,,,,
[<DESC>]”
;
where:
• <AID> is the identifier that has an alarm condition and is from the “EQPT”
section on page 4-11
• <AIDTYPE> is the type of the AID. It is always reported as EQPT for the
equipment condition; valid values for <AIDTYPE> are shown in the “MOD2B”
section on page 4-45, <AIDTYPE> is optional
• <NTFCNCDE> is the notification code; valid values for <NTFCNCDE> are
shown in the “NOTIF_CODE” section on page 4-49, <NTFCNCDE> is optional
• <TYPEREQ> is the type of condition to be retrieved; valid values for
<TYPEREQ> are shown in the “CONDITION” section on page 4-24
• <SRVEFF> is the effect on service caused by the alarm condition; valid values
for <SRVEFF> are shown in the “SERV_EFF” section on page 4-56,
<SRVEFF> is optional
• <DESC> is the condition description; <DESC> is a string and is optional
Output
Example
TID-000 1998-06-20 14:30:00
M 001 COMPLD
“SLOT-1,EQPT:CR,LOS,SA,,,,,\“LOS OF SIGNAL\””
;
Errors This message generates all the default errors
Section RTRV-COND-EQPT Description (continued)