Specifications

3-125
Cisco ONS 15454 and Cisco ONS 15327 TL1 Command Guide, R3.3
May 2002
Chapter 3 TL1 Command Descriptions
TL1 Commands
3.5.88 RTRV-ATTR-CONT: Retrieve Attribute Control
This command instructs the NE to send the attributes associated with an external control. These
attributes are used when an external control is operated or released. To set these attributes, use the
SET-ATTR-CONT command.
Output Format SID DATE TIME
M CTAG COMPLD
“<AID>,[<AIDTYPE>]:<NTFCNCDE>,<CONDTYPE>,<SRVEFF>,,,,:
[<DESC>]”
;
where:
• <AID> is the identifier that has an alarm condition and is from the “SYN” section
on page 4-14
• <AIDTYPE> is the type of access identifier: valid values for <AIDTYPE> are
shown in the “MOD2B” section on page 4-45 and <AIDTYPE> is optional
• <NTFCNCDE> is the 2-letter notification code; valid values for <NTFCNCDE>
are shown in the “NOTIF_CODE” section on page 4-49
• <CONDTYPE> is the alarm condition; valid values for <CONDTYPE> are
shown in the “CONDITION” section on page 4-24
• <SRVEFF> is the effect on service caused by the alarm condition; valid values
for <SRVEFF> are shown in the “SERV_EFF” section on page 4-56
• <DESC> is the condition description; <DESC> is a string and is optional
Example TID-000 1998-06-20 14:30:00
M 001 COMPLD
“SYNC-NE,SYNCN:CR,FAILTOSW,SA,,,,:\“FAILURE TO SWITCH TO
PROTECTION\”,”
;
Errors This message generates all the default errors
Section RTRV-ALM-SYNCN Description (continued)
Section RTRV-ATTR-CONT Description
Category Environmental Alarms and Controls
Security Retrieve
Related
Messages
OPR-EXT-CONT RTRV-ATTR-ENV
REPT ALM ENV RTRV-COND-ENV
REPT EVT ENV RTRV-EXT-CONT
RLS-EXT-CONT SET-ATTR-CONT
RTRV-ALM-ENV SET-ATTR-ENV