Specifications

3-121
Cisco ONS 15454 and Cisco ONS 15327 TL1 Command Guide, R3.3
May 2002
Chapter 3 TL1 Command Descriptions
TL1 Commands
3.5.85 RTRV-ALM-EQPT: Retrieve Alarm Equipment
This command instructs the NE to retrieve and send the current status of its alarm conditions associated
with the equipment units. The alarm condition or severity to be retrieved is specified using the input
parameters as a filter.
Section RTRV-ALM-EQPT Description
Category Equipment
Security Retrieve
Related
Messages
ALW-SWDX-EQPT RTRV-ALM-<MOD2ALM>
ALW-SWTOPROTN-EQPT RTRV-ALM-ALL
ALW-SWTOWKG-EQPT RTRV-ALM-BITS
DLT-EQPT RTRV-ALM-ENV
ED-EQPT RTRV-ALM-RING
ENT-EQPT RTRV-ALM-SYNCN
INH-SWDX-EQPT RTRV-COND-<MOD2ALM>
INH-SWTOPROTN-EQPT RTRV-COND-ALL
INH-SWTOWKG-EQPT RTRV-COND-BITS
REPT ALM <MOD2ALM> RTRV-COND-ENV
REPT ALM BITS RTRV-COND-EQPT
REPT ALM COM RTRV-COND-RING
REPT ALM ENV RTRV-COND-SYNCN
REPT ALM EQPT RTRV-EQPT
REPT ALM RING SW-DX-EQPT
REPT ALM SYNCN SW-TOPROTN-EQPT
REPT ALM COM SW-TOWKG-EQPT
REPT EVT EQPT
Input Format RTRV-ALM-EQPT:[<TID>]:<AID>:<CTAG>::[<NTFCNCDE>],[<CONDTYPE>],
[<SRVEFF>][,,,];
where:
• <AID> is the identifier that has an alarm condition and is from the “EQPT”
section on page 4-11; <AID> must not be null
• <NTFCNCDE> is the 2-letter notification code; valid values for <NTFCNCDE>
are shown in the “NOTIF_CODE” section on page 4-49. A null value is
equivalent to ALL.
• <CONDTYPE> is the alarm condition; valid values for <CONDTYPE> are
shown in the “CONDITION” section on page 4-24. A null value is equivalent to
ALL.
• <SRVEFF> is the effect on service caused by the alarm condition; valid values
for <SRVEFF> are shown in the “SERV_EFF” section on page 4-56. A null value
is equivalent to ALL.
Input Example RTRV-ALM-EQPT:TWOROCK:SLOT-7:227::MJ,HITEMP,NSA;