Specifications

3-119
Cisco ONS 15454 and Cisco ONS 15327 TL1 Command Guide, R3.3
May 2002
Chapter 3 TL1 Command Descriptions
TL1 Commands
3.5.84 RTRV-ALM-ENV: Retrieve Alarm Environment
This command retrieves the environmental alarms.
Output Format SID DATE TIME
M CTAG COMPLD
“<AID>,[<AIDTYPE>]:<NTFCNCDE>,<CONDTYPE>,<SRVEFF>,,,,:
[<DESC>]”
;
where:
• <AID> is the identifier that has an alarm condition and is from the “BITS”
section on page 4-9
• <AIDTYPE> is the type of access identifier; valid values for <AIDTYPE> are
shown in the “MOD2B” section on page 4-45 and <AIDTYPE> is optional
• <NTFCNCDE> is the 2-letter notification code; valid values for <NTFCNCDE>
are shown in the “NOTIF_CODE” section on page 4-49
• <CONDTYPE> is the alarm condition; valid values for <CONDTYPE> are
shown in the “CONDITION” section on page 4-24
• <SRVEFF> is the effect on service caused by the alarm condition; valid values
for <SRVEFF> are shown in the “SERV_EFF” section on page 4-56
• <DESC> is the condition description; <DESC> is a string and is optional
Output
Example
TID-000 1998-06-20 14:30:00
M 001 COMPLD
“BITS-1,BITS:CR,LOS,SA,,,,:\“LOSS OF SIGNAL\”,”
;
Errors This message generates all the default errors
Section RTRV-ALM-BITS Description (continued)
Section RTRV-ALM-ENV Description
Category Environmental Alarms and Controls
Security Retrieve
Related
Messages
OPR-EXT-CONT RTRV-ALM-RING
REPT ALM <MOD2ALM> RTRV-ALM-SYNCN
REPT ALM BITS RTRV-ATTR-CONT
REPT ALM COM RTRV-ATTR-ENV
REPT ALM ENV RTRV-COND-<MOD2ALM>
REPT ALM EQPT RTRV-COND-ALL
REPT ALM RING RTRV-COND-BITS
REPT ALM SYNCN RTRV-COND-ENV
REPT EVT COM RTRV-COND-EQPT
REPT EVT ENV RTRV-COND-RING
RLS-EXT-CONT RTRV-COND-SYNCN
RTRV-ALM-<MOD2ALM> RTRV-EXT-CONT
RTRV-ALM-ALL SET-ATTR-CONT
RTRV-ALM-BITS SET-ATTR-ENV
RTRV-ALM-EQPT