Specifications

3-110
Cisco ONS 15454 and Cisco ONS 15327 TL1 Command Guide, R3.3
May 2002
Chapter 3 TL1 Command Descriptions
TL1 Commands
Output Format SID DATE TIME
M CTAG COMPLD
“<AID>:,,[<ROLE>],[<STATUS>]:[DCC=<DCC>,][TMGREF=<TMGREF>,]
[SYNCMSG=<SYNCMSG>,][SENDDUS=<SENDDUS>,][PJMON=<PJMON>,]
[SFBER=<SFBER>,][SDBER=<SDBER>,][MODE=<MODE>,]
[WVLEN=<WVLEN>,][RINGID=<RINGID>,][BLSRTYPE=<BLSRTYPE>,]
[MUX=<MUX>]:[<PST>]”
;
where:
• <AID> is the access identifier from the “FACILITY” section on page 4-11
• <ROLE> identifies the OCN port role (e.g. WORK or PROT); valid values for
<ROLE> are shown in the “SIDE” section on page 4-56, <ROLE> is optional
• <STATUS> identifies the OCN port status (e.g. Active or Standby); valid values
for <STATUS> are shown in the “STATUS” section on page 4-57, <STATUS> is
optional
• <DCC> identifies the OCN port DCC connection and defaults to N; valid values
for <DCC> are shown in the “ON_OFF” section on page 4-51, <DCC> is
optional
• <TMGREF> identifies if the OCN port has timing reference and defaults to N;
valid values for <TMGREF> are shown in the “ON_OFF” section on page 4-51,
<TMGREF> is optional
• <SYNCMSG> indicates if sync status messaging is enabled or disabled on the
facility; <SYNCMSG> defaults to Y and the valid values are shown in the
“ON_OFF” section on page 4-51. <SYNCMSG> is optional.
• <SENDDUS> indicates that the facility will send out the DUS (do not use for
synchronization) value as the sync status message for that facility; <SENDDUS>
defaults to N and the valid values are shown in the “ON_OFF” section on
page 4-51. <SENDDUS> is optional
• <PJMON> identifies the OCN port PJMON; <PJMON> defaults to 0 (zero), is
an integer and is optional
• <SFBER> identifies the OCN port SFBER and defaults to 1E-4; valid values for
<SFBER> are shown in the “SF_BER” section on page 4-56, <SFBER> is
optional
• <SDBER> identifies the OCN port SDBER and defaults to 1E-7; valid values for
<SDBER> are shown in the “SD_BER” section on page 4-55, <SDBER> is
optional
• <MODE> identifies the OCN port mode (e.g. SONET, SDH) and defaults to
SONET; valid values for <MODE> are shown in the “OPTICAL_MODE”
section on page 4-51, <MODE> is optional
• <WVLEN> identifies the OCN port wavelength; <WVLEN> is wavelength in nm
(nanometer) for unit, e.g. WVLEN=1310.00 means it operates at 1310 nm in the
DWM application. <WVLEN> is a Float and is optional
• <RINGID> identifies the BLSR ID with which the port is connected. The
<RINGID> ranges from 0 to 9999; <RINGID> is an integer and is optional
Section RTRV-<OCN_TYPE> Description (continued)