Specifications

3-107
Cisco ONS 15454 and Cisco ONS 15327 TL1 Command Guide, R3.3
May 2002
Chapter 3 TL1 Command Descriptions
TL1 Commands
3.5.76 RLS-SYNCNSW: Release Synchronization Switch
This command releases the previous synchronization reference provided by the OPR-SYNCNSW
command. The timing reverts back to its previous mode.
In a non-revertive system, the use of the RLS-SYNCNSW command may not be appropriate. All the
switching between synchronization references should be initiated with the OPR-SYNCNSW command.
Once a switch is in effect, a minor alarm “MANSWTOPRI”, Manual Switch to Primary Reference (or
Secondary...), will be raised.
Section RLS-PROTNSW-VT1 Description
Category UPSR Switching
Security Maintenance
Related
Messages
OPR-PROTNSW-<STS_PATH>
OPR-PROTNSW-VT1
REPT SW
RLS-PROTNSW-<STS_PATH>
Input Format RLS-PROTNSW-VT1:[<TID>]:<AID>:<CTAG>[::];
where:
• <AID> identifies the entity in the NE to which the switch request is directed and
is from the “VT1_5” section on page 4-17
Input Example RLS-PROTNSW-VT1:CISCO:VT1-4-2-3-1:123;
Errors This message generates all the default errors
Section RLS-SYNCNSW Description
Category Synchronization
Security Maintenance
Related
Messages
ED-BITS RTRV-ALM-BITS
ED-NE-SYNCN RTRV-ALM-SYNCN
ED-SYNCN RTRV-BITS
OPR-SYNCNSW RTRV-COND-BITS
REPT ALM BITS RTRV-COND-SYNCN
REPT ALM SYNCN RTRV-NE-SYNCN
REPT EVT BITS RTRV-SYNCN
REPT EVT SYNCN
Input Format RLS-SYNCNSW:[<TID>]:[<AID>]:<CTAG>;
where:
• <AID> is the access identifier from the “SYNC_REF” section on page 4-15. A
null value of AID defaults to SYNC-NE.
Input Example RLS-SYNCNSW:CISCO:SYNC-NE:3;
Errors This message generates all the default errors