Specifications

3-103
Cisco ONS 15454 and Cisco ONS 15327 TL1 Command Guide, R3.3
May 2002
Chapter 3 TL1 Command Descriptions
TL1 Commands
3.5.70 REPT SW: Report Switch
(Cisco ONS 15454 only)
Reports the autonomous switching of an active unit in a duplex equipment pair to the standby state and
its mate to the active state. An automatic report for the occurrence or clearance of an alarm or event that
triggers the switch may be associated with the message.
3.5.71 RLS-EXT-CONT: Release External Control
This command is used to release a forced contact state and returns the control of the contact to an
AUTOMATIC control state. In AUTOMATIC control state, the contact could be opened or closed
depending on triggers that may or may not be provisioned in the NE. Therefore, issuing an RLS might
not produce any contact state change.
The NE defaults to having no triggers provisioned for external controls which consequently produces
default open contacts. An NE with this default provisioning will always produce an open contact with a
RLS-EXT-CONT command.
Notes:
1. The duration is not supported, it defaults to CONTS.
2. In an automatic state, the contact could be opened or closed depending on the provisioned trigger.
Therefore, issuing an OPR-EXT-CONT command followed by an RLS-EXT-CONT command might
not produce any contact state change.
Section REPT SW Description
Category UPSR Switching
Security Retrieve
Related
Messages
OPR-PROTNSW-<STS_PATH>
OPR-PROTNSW-VT1
RLS-PROTNSW-<STS_PATH>
RLS-PROTNSW-VT1
Output Format SID DATE TIME
A ATAG REPT SW
“<ACTID>,<STDBYID>”
;
where:
• <ACTID> identifies the equipment unit that has been placed in the active state.
Parameter grouping cannot be used with this parameter; <ACTID> is the AID
from the “EQPT” section on page 4-11
• <STDBYID> identifies the equipment unit that was placed in the standby state.
Parameter grouping cannot be used with this parameter; <STDBYID> is the
AID from the “EQPT” section on page 4-11
Output
Example
TID-000 1998-06-20 14:30:00
A 001 REPT SW
“SLOT-8,SLOT-10”
;