Specifications

3-101
Cisco ONS 15454 and Cisco ONS 15327 TL1 Command Guide, R3.3
May 2002
Chapter 3 TL1 Command Descriptions
TL1 Commands
3.5.68 REPT EVT SECU: Report Event Security
Reports the occurrence of a non-alarmed security even against the NE.
Based on TR-NWT-000835 in TR-NWT-000835 and the AID of the security alarm should be the
Connection Identifier (CID) which is not supported in this release. The COM or UID is an acceptable
substitute for the AID here. CID’s will be supported in a future release.
For the rule of single failure, single message/alarm, the security alarm will not be reported as
REPT ALM COM, because it is reported as REPT ALM SECU.
Because the NE sends this security message as a transient message, to make all TL1 autonomous
messages consistent, the TL1 agent reports the security message into REPT EVT SECU.
Section REPT EVT SECU Description
Category Security
Security Retrieve
Related Messages ACT-USER
CANC
CANC-USER
DLT-USER-SECU
ED-PID
ED-USER-SECU
ENT-USER-SECU
Output Format SID DATE TIME
A ATAG REPT EVT SECU
“<AID>:<CONDTYPE>,[<CONDEFF>],,,,,,,:[<DESC>]”
;
where:
• <AID> identifies an entity with the condition and defaults to “COM”; <AID>
is a string
• <CONDTYPE> is the condition type and valid values are shown in the
“CONDITION” section on page 4-24
• <CONDEFF> indicates an effect of the condition on the NE and valid values
are shown in the “COND_EFF” section on page 4-24; <CONDEFF> is
optional
• <DESC> is the condition description; <DESC> is a string and is optional
Output Example TID-000 1998-06-20 14:30:00
A 001 REPT EVT SECU
“COM:INTRUSION,TC,,,,,,,:\“SECURITY-INVALID LOGIN
(SEE AUDIT TRIAL)\””
;