Specifications

3-89
Cisco ONS 15454 and Cisco ONS 15327 TL1 Command Guide, R3.3
May 2002
Chapter 3 TL1 Command Descriptions
TL1 Commands
3.5.56 REPT ALM COM: Report Alarm COM
Reports an alarm condition when an AID cannot be given, for example, a fan failure is reported using
this message.
Section REPT ALM COM Description
Category Fault
Security Retrieve
Related
Messages
REPT ALM <MOD2ALM> RTRV-ALM-EQPT
REPT ALM BITS RTRV-ALM-RING
REPT ALM ENV RTRV-ALM-SYNCN
REPT ALM EQPT RTRV-COND-<MOD2ALM>
REPT ALM RING RTRV-COND-ALL
REPT ALM SYNCN RTRV-COND-BITS
REPT EVT COM RTRV-COND-ENV
RTRV-ALM-<MOD2ALM> RTRV-COND-EQPT
RTRV-ALM-ALL RTRV-COND-RING
RTRV-ALM-BITS RTRV-COND-SYNCN
RTRV-ALM-ENV
Output Format SID DATE TIME
** ATAG REPT ALM COM
“[<AID>]:<NTFCNCDE>,<CONDTYPE>,<SRVEFF>,,,,:[<DESC>]”
;
where:
• <AID> indicates the alarm without AID; <AID> is a string and is optional
• <NTFCNCDE> indicates a notification code; valid values for <NTFCNCDE>
are shown in the “NOTIF_CODE” section on page 4-49
• <CONDTYPE> indicates an alarm condition; valid values for <CONDTYPE>
are shown in the “CONDITION” section on page 4-24
• <SRVEFF> is the effect on service caused by the alarm condition; valid values
for <SRVEFF> are shown in the “SERV_EFF” section on page 4-56
• <DESC> is the condition description; <DESC> is a string and is optional
Output
Example
TID-000 1998-06-20 14:30:00
** 001 REPT ALM COM
“COM:MJ,FAN,NSA,,,,:\“FAN FAILURE\””
;