Specifications

3-86
Cisco ONS 15454 and Cisco ONS 15327 TL1 Command Guide, R3.3
May 2002
Chapter 3 TL1 Command Descriptions
TL1 Commands
3.5.53 OPR-SYNCNSW: Operate Synchronization Switch
This command forces the NE to switch to the reference specified by the synchronization reference
number if the reference supplied is valid, otherwise the command will fail.
The Operate Synchronization Switches are released by the RLS-SYNCNSW command or are overridden
by a synchronization reference failure.
Once the switch is effective, an event “MANSWTOPRI”, Manual Switch to Primary (or Secondary ...)
Reference, will be raised
.
Section OPR-SYNCNSW Description
Category Synchronization
Security Maintenance
Related
Messages
ED-BITS RTRV-ALM-BITS
ED-NE-SYNCN RTRV-ALM-SYNCN
ED-SYNCN RTRV-BITS
REPT ALM BITS RTRV-COND-BITS
REPT ALM SYNCN RTRV-COND-SYNCN
REPT EVT BITS RTRV-NE-SYNCN
REPT EVT SYNCN RTRV-SYNCN
RLS-SYNCNSW
Input Format OPR-SYNCNSW:[<TID>]:[<AID>]:<CTAG>::<SWITCHTO>;
where:
• <AID> is the access identifier from the “SYNC_REF” section on page 4-15. A
null value of <AID> defaults to SYNC-NE.
• <SWITCHTO> identifies the new synchronization reference that will be used
and is the AID from the “SYNCSW” section on page 4-16
Input Example OPR-SYNCNSW:CISCO:SYNC-NE:3::PRI;
Errors This message generates all the default errors